Carbonit IFP Puro water filter

As IFP Puro combines the special properties of a sintered CARBONIT® monoblock with a microfiltration of 0.15 µm through the internal Ster-O-Tap® capillary membrane. Even high loads that could accumulate in the organism are reliably removed and stored. The IFP Puro type filter cartridges are ideal at low line pressure and allow bacterial loads to be contained. The Ster-O-Tap® capillary membrane is tested according to ANSI/NSF Standard 53 (Cyst and Turbidity Reduction).

• length 9 3/4", da= 70

The filter cartridge must be replaced after 6 months (according to DIN 1988). In principle, 5,000 liters of water may be filtered within the 6 months. However, an earlier change may be necessary if the water flow is noticeably reduced. An early change is not a defect of the filter used, but an indication of increased occurrence of fine particles in the unfiltered water.

Filter fineness: 0.15 µm (membrane) 5 µm (activated carbon)

Dimensions: length 9 3/4", da= 70

Flow rate: approx. 8 liters per minute

Temperature: use only with cold water, protect from frost

CARBONIT® Monoblock IFP Puro filter cartridges fit to the following filter units: SANUNO, VARIO, DUO HPS/DUO HPP