Molto Moisture blocker spray 0.5 l white matt drying

For insulating damp and wet walls. Ideal for insulating damp and wet walls indoors and outdoors. Also for sealing moisture in masonry, on plastered walls, on concrete, in cellars, on foundations, in damp rooms such as bathrooms, showers, kitchens, on retaining walls, wells and pflanking arches. Can be used on all mineral substrates that do not contain gypsum. E.g. on masonry made of sand-lime bricks, aerated concrete blocks, bricks, etc. Molto Feucht Blocker can be used above and below the ground and can also be applied to slightly damp substrates. Application: The substrate must be sufficiently firm and load-bearing and free of layers that reduce adhesion, e.g. dust, dirt and loose particles. Close cracks, holes and unevenness with a suitable Molto powder filler. Consolidate slightly sanding plaster layers with Molto Deep Primer. Remove salt efflorescence from the masonry with Molto Saltpetre Remover. Prevent further moisture from penetrating the masonry by taking appropriate measures. Shake Molto Moisture Blocker well for at least one minute before use - the product is ready to use. Spray on the coats evenly. As a rule, two coats are sufficient. If the substrate is very porous, three coats should be applied. The previous coat must be thoroughly dry before applying the second or third coat. Once completely dry, Molto Feucht Blocker can be painted over with alkali-resistant emulsion paints. Ingredients: acrylate resin, titanium dioxide, fillers, solvents, additives, propellant Range: 2-4 m²

• Simply spray on
• Fast drying
• Alkali- and mold-resistant
• Good insulating effect due to formation of a protective layer
• Can be used on damp substrates