Simpson Strong-Tie Gerber connector GERW140-B

the GERW Gerber connectors are suitable for the joint formation of butt-joined continuous beams, in addition to shear forces in the vertical and horizontal direction, they can absorb forces in the direction of the bar and are therefore suitable for the transmission of association forces, depending on the load, you can choose between partial and full nailing tensile forces (FN,d) that occur, partial nailing should always be selected, the type designation corresponds to the height of the connector, for a given purlin height a set of connectors is used that is 20 mm smaller than the purlin height, but for purlin heights of 100 and 125 mm it is used type GERW 90 is used, steel quality: S 250 GD + Z 275 according to DIN EN 10346, corrosion protection: 275 gm2 on both sides - corresponds to a zinc layer thickness of approx. 20 ?m, advantage: load transfer in all three directions, optimized load-bearing capacity for full and partial nailing , single dimension suitable for several wood cross-sections - storage space saving , Support: wood, wood-based materials, component to be supported: wood, wood-based materials, area of application: coupling purlin connection for wood cross-section heights of 90 to 420 mm

Packing unit: 20 pcs.