Normstahl RCU 433 4K handheld transmitter 433 Mhz

GENERAL INSTRUCTIONS FOR SETTING UP A HANDHELD TRANSMITTER WITHOUT DIP SWITCHES

Before you can use your new hand-held transmitter, you must teach it into your receiver or control unit. To do this, open the radio receiver or control unit on the gate or operator. It is best to follow the antenna cable, it leads directly to the receiver unit. But be careful! The system could be live!

Pay attention to:
1. open the radio receiver and look at the circuit board. There you should see a learn button. This can be labeled as follows: LEARN, MEMORY, PROGRAM, PRG, P, M, L, K1 or 1. 2.
2. press the button for max. 2 seconds, after which a tone may sound or an LED may light up/flash. Now the receiver is in the learning mode. 3.
3. now press the desired channel key on the new handheld transmitter for at least 3 seconds ( Attention, the gate could move!).

Now this key is taught-in. To teach-in further buttons if necessary, repeat steps 2 and 3.

Tip:
Since these are only general instructions that apply to most receivers, always refer to the description of the supplied handheld transmitter (if available) and that of your gate receiver/controller.