Alpen Tile Drill C Protector New PLT ø 6.0 mm

The ALPEN Tile Drill C Protector New PLT has been designed for precise and crack-free drilling in extremely hard porcelain stoneware tiles. With an optimized geometry and significantly improved cutting performance, the second generation of the C Protector sets new technical standards. The drill achieves up to 156% more drillings and operates about 31% faster than the previous model. The result is a noticeably higher tool life with reduced wear and consistently high drilling quality. It is suitable for porcelain stoneware tiles up to Mohs or scratch hardness 9, as well as for glass and porcelain. The drill is designed for dry drilling and does not require cooling. Use in hammer drilling mode is not intended.

• Optimized drill geometry ensures precise and crack-free holes even under demanding conditions
• Suitable for extremely hard porcelain stoneware tiles up to Mohs or scratch hardness 9, as well as for glass and porcelain
• Increased cutting performance allows for up to 156% more drillings compared to the previous model
• Faster drilling progress with about 31% time savings enhances efficiency and cost-effectiveness
• HM plate with patented special grinding supports clean and controlled drilling results
• Shortened neck increases stability and reduces material stress during the drilling process
• Centering tip allows for precise placement without wandering on hard surfaces
• Anti-slip shaft ensures a secure grip in all common drill chucks
• Designed for dry drilling without additional cooling at a maximum spindle speed of 600 RPM depending on the diameter
• Not suitable for use in hammer drilling mode