Proxxon Fine turning machine FD 150/E

Fine turning lathe FD 150/E

2-stage belt drive and additional electronic control enable spindle speeds of up to 5,000 rpm. The right cutting speed even for the smallest parts. For facing, longitudinal turning, boring, taper turning, parting off and drilling. Complete with 3-jaw chuck and live center point. Center width 150 mm. Center height 55 mm. Center height above support 33 mm.

Machine bed: With dovetail guide made of continuous cast aluminum.

Headstock: Made of die-cast aluminum. With quiet DC special motor, 2-stage belt drive and additional speed control: for high pulling power at lower speeds for larger workpieces and for the right cutting speed even for the smallest parts. Relay switch with emergency stop function and restart protection. Precision-bearing main spindle with continuous 8.5 mm bore. Chuck-side fit for standard collets type ER 11.

Three-jaw chuck: Centric clamping (inner jaws 1 - 20 mm, outer jaws 20 - 60 mm).

Tailstock: Made of die-cast aluminum. With quill and moving center point (fit MK 0/short).

Support: Is moved manually on the bed and clamped with a lever. Rotatable steel holder for turning steel 6 x 6 mm. Processing is carried out with top slide (60 mm travel) and cross slide (40 mm travel). By adjusting the angle of the top slide, it is possible to turn cones up to +/- 45°.

Setting wheels: With scale ring adjustable to 0 (1 graduation mark = 0.05 mm, 1 revolution = 1 mm).

Other technical data:
220 - 240 Volt. 50/60 Hz. Center width 150 mm. Tip height 55 mm. Center height above support 33 mm. Adjustment travel face slide (X) 40 mm, top slide (Z) 60 mm. Steel holder for turning steel 6 x 6 mm. Spindle clearance 8.5 mm. 2-stage belt drive with speed control: Stage 1 = 800 - 2,800 rpm. Stage 2 = 1,500 - 5,000 rpm. Size approx. 360 x 150 x 150 mm. Weight approx. 4.5 kg. Built according to protection class 1.
Material: headstock + tailstock: die-cast aluminum; machine bed: continuous cast aluminum

• Machine bed: With dovetail guide made of continuous cast aluminum
• Headstock: Made of die-cast aluminum. With quiet DC special motor
• Three-jaw chuck: Centric clamping (inner jaws 1 - 20 mm, outer jaws 20 - 50 mm)
• Tailstock: Made of die-cast aluminum. With quill and moving center point
• Support: Is moved manually on the bed and clamped with a lever