DTM Radio receiver from Rival 862 radio receiver

The 2-channel radio receiver Rival 862 from DTM with a voltage of 12-24V is mainly used to control entrance and garage doors, shutters, lighting and alarm systems. It has two separate channels of type NO. The switch-on time is also freely adjustable! In addition, the memory capacity is sufficient for up to 200 hand-held transmitters!

New: innovative coding system IRS and memory for 200 hand-held transmitters!

• Frequency: 868 MHz
• Modulation: FSK
• the highest level of security against copying
• intelligent adaptation to different radio conditions

Technical data of the radio receiver:

• Power supply: 12 ... 24V AC / DC ± 10%
• Max. Current consumption: 100 mA
• Memory: 200 hand-held transmitters, each with its own ID
• Operating temperature: -20 ° C / + 55 ° C
• Dimensions (housing): 55 x 27.5 x 118 mm
• Dimensions (board): 46 x 80 x19 mm
• Mounting: ABS housing, IP 53
• Weight: 42g
• Relay outputs (type / number / max. Load): NO / 2 / 1A (24V AC / DC)
• Output modes: monostable, bistable or short-term
• Switch-on time in monostable mode adjustable: 0.5 sec., 1 to 127 sec., Resolution 1 sec. 1 min. To 127 min., Resolution 1 min.
• Radio module: digital, integrated and superheterodyne, offers maximum reliability, resistant to radio interference
• Coding type: 104-bit IRS
• Modulation / Frequency: FSK / 868MHz
• Antenna Impedance: 50?
• Antenna: indoor antenna, connection terminals for outdoor antenna
• Interface: very clear and simple, based on two buttons with two built-in LED diodes
• Transmitter configuration: any function-key assignment
• Clear entire memory: Yes
• Deletion of individual transmitters: Yes, the transmitter to be deleted must be available
• Reading in individual transmitters without access to the receiver: Yes, (remote learning)
• Possibility to check the number of stored handheld transmitters: Yes